total arthrodesis

The Achilles tendon, the distance between the boat and the heel joint, the joint ankle joint (ie, the ankle joint) fusion, called the four joint fusion, also known as talar fusion. There are two approaches: one-stage surgery and staged surgery. Staging surgery is to avoid ischemic necrosis of the talus, but clinical practice has proved that staging surgery is painful, long cycle, and the curative effect is not better than that of the first-stage surgery. Therefore, it advocates one-stage operation. Treatment of diseases: ankle joint dislocation ankle fracture Indication Full-length arthrodesis is suitable for: 1. Even the ankles, the ankle joints are extremely unstable. 2. Severe horseshoe varus deformity, more than 170 °. 3. After three-joint fusion, ankle pain, degenerative changes, traumatic arthritis or ischemic necrosis of the talus. Contraindications 1.12 years old or younger. 2. The same side limb ankle or contralateral limb ankle has been strong. Preoperative preparation Take X-ray films to understand the bone structure and deformity of the whole foot and ankle, and estimate the extent of the osteotomy and the angle of correction during the operation. Surgical procedure 1. The incision is made from the lateral aspect of the anterior tibial tendon to the base of the third and fourth metatarsal bones from 3 to 4 cm on the ankle joint, and the length is 8 to 10 cm. Cut the skin and subcutaneous tissue. 2. Cut the deep fascia on the outside of the extensor tendon of the toe and the transverse ligament of the lower leg. Push the soft tissue to both sides to expose the ankle joint and the joint of the scaphoid. The operation should be close to the bone surface to prevent damage to the dorsal artery of the foot. 3. The forefoot adduction and abduction, respectively, cut the joint capsule and ligament around the talus, and then the forefoot extreme plantar flexion, visible talus posterior process. The attached ligament was cut, the talus was pulled out with a periosteal screwdriver, and the cartilage surface of the talus was removed by clamping with a cloth towel. Then, the lower end of the humerus, the cartilage surface above the calcaneus, and the cartilage surface of the scaphoid and tibia are sequentially removed, and the talus is placed back into the acupoint. 4. Extend the back of the foot to maintain the ankle joint extension. If the talus is in close contact with the surrounding bone, the cancellous bone can be filled. 5. Use a Kirschner wire to fix the foot from the plantar bone to the lower end of the tibia to the functional position. 6. Incision suture to relax the tourniquet, completely stop bleeding, isotonic saline to wash the wound, sutured according to the level.

Was this article helpful?

The material in this site is intended to be of general informational use and is not intended to constitute medical advice, probable diagnosis, or recommended treatments.