fascia lata suspension

The material of the fascial fascia suspension can be taken from the body, or the preserved allogeneic fascia can be used, and even the different kind of calf fascia can be used. The fascia used in ophthalmology is a fascia. The absorption of the allogeneic fascia is not obvious after transplantation, because the source is abundant, the operation is simple, and the pain of the patient can be alleviated, which is worth promoting. The fascia lata can be used as an ideal suspension material for valgus valgus surgery caused by ptosis and facial nerve paralysis. The fascia can also be folded into several layers as a filling material. In addition, the width of the eyelid margin is insufficient or disappeared, and the vaginal varus can be cut open, and the fascia can be embedded therein to increase the width between the gingival margins and correct the varus. Treatment of diseases: ptosis, surgical procedure 1. Make an incision of 8-12 cm in the middle of the lateral part of the thigh, bluntly separate the fat, reveal the fascia, make a pair of parallel incisions on the fascia (do not damage the muscle fibers underneath), the width between the parallel incisions, according to It depends on the amount of fascia. Generally, the double side suspension can take 1.2cm, and the single side can take 0.6cm width. 2. Use a blunt-head scissors to make a blunt separation between the fascia and the muscle. The length of the separation is 8 to 12 cm. 3. Pull the upper end of the skin incision upward with a hook, cut the upper end of the fascia strip, and then pull the skin incision downwards, cut the lower end of the fascia strip, remove the fascia strip, cut off the fat attached to the fascia, and trim it to a width of 3 mm. Fascia strips. 4. The fascial wound edge was sutured intermittently with No. 0 silk thread, and the skin incision was also sutured intermittently with No. 0 silk thread. In order to prevent the formation of tendon, the bandage was pressure-wrapped and the incision was performed 10 days after the operation. 5. Using the stripper extraction method, make a horizontal incision of 3 cm in length at the lower end of the fascia site, and open the incision with a hook to cut the fascia vertically, so that the lower end of the fascia is free. Hold the lower end of the fascia with a vascular clamp, extend the stripper into the incision, push the fascia one by one, push the stripper up to the required length with the other hand, and rotate the stripper to cut the upper end of the fascia, remove the fascia strip, and suture the skin. , pressure bandage.